BH-40 – 4,000 lb. Standard Flat-Plate Boat Hoist

The BH-40 – 4,000 lb standard flat-plate boat hoist is made up of an Elite 0.75 HP painted electric motor with base and a 4,000 lb standard gear plate assembly. The Elite 1 HP Painted Wired Boat Lift Motor is a single phase, dual-voltage motor. It comes from the factory wired at 220v, but a licensed electrician can convert the wiring to make it a 110v electric motor. The motor is built from rolled steel. The NEMA 56 shaft is 0.625 inch thick and 1.88 inch extruding from the motor housing. UL Recognized (C-UL-US). It uses a capacitor to start.

TENV (totally enclosed, non-ventilated) housing. TENV housing prevents dirt, insects, and water from entering the motor. 15 minutes maximum runtime. Includes 1 inch long x 1/4 inch wide keystock, colored T-wires, easy-to-follow wiring instructions, BH-USA equipment guide, and wiring instructions. Depending on your preference, you can select a maintained (lock-on) or momentary (spring-loaded) drum switch type. The in-line GFCI has a built-in test and reset button.

The 4,000 lb Standard Gear Plate Assembly has a rated lifting capacity of up to 4,000 lbs when used with a 1 HP electric motor. BH-USA uses this gear plate with all its Standard Series flat-plate boat hoists. There are no steel-on-steel moving parts. Assembled and tested by the manufacturer. Lifetime warranty included.

The short block worm assembly has a 2-inch bearing block, a worm on a driveshaft, and an aluminum housing with 1/4 inch grease fittings. Attaches directly to the gear plate. The assembly has standard flat-plate mounting holes. The 96 tooth worm gear assembly comes assembled with the gear, sleeve, backplate bearing, axle sleeve bolt, and snap rings. 1/4 inch easy-reach grease fittings are included. The gear fits standard gear plates used in flat-plate hoists.