BH-45 – 4,500 lb. Deluxe Flat-Plate Boat Hoist

The BH-45 – 4,500 lb. Deluxe Flat-Plate Boat Hoist is made up of an Elite 1 HP painted electric motor with base and a 6,500 lb deluxe gear plate assembly. The Elite 1 HP Painted Wired Boat Lift Motor is a single phase, dual-voltage motors. It comes from the factory wired at 220v, but a licensed electrician can convert the wiring to make it a 110v electric motor. The motor is built from rolled steel. The NEMA 56 shaft is 0.625 inch thick and 1.88 inch extruding from the motor housing. UL Recognized (C-UL-US). It uses a capacitor to start.

TENV (totally enclosed, non-ventilated) housing. TENV housing prevents dirt, insects, and water from entering the motor. 15 minutes maximum runtime. Includes 1 inch long x 1/4 inch wide keystock, colored T-wires, easy-to-follow wiring instructions, BH-USA equipment guide, and wiring instructions. Depending on your preference, you can select a maintained (lock-on) or momentary (spring-loaded) drum switch type. The in-line GFCI has a built-in test and reset button.

The Extended Block Worm Assembly has a 2-inch bearing block, a worm on a driveshaft, and an aluminum housing with 1/4 inch grease fittings. Attaches directly to the gear plate. The assembly has standard flat-plate mounting holes. The assembly is fitted with standard flat-plate mounting holes Factory assembled. Blocks are fitted with flange bushings. They have 1/4-inch grease fittings, which can be accessed easily.

The 6,500 lb. Deluxe Gear Plate Assembly includes the 10-inch aluminum die-cast hoist pulley, 96-tooth cast iron worm gear assembly, extended block bronze worm assembly and 34-inch drive belt. There are no steel-on-steel moving parts. It has been assembled and tested by the manufacturer. The 10 in. Aluminum Die-Cast Hoist Pulley is made from an aluminum die-casting process. Over 15 years of use on BH-USA Flat Plate hoists. They are much stronger in marine environments. They will not swell or bend. The belt-gripping technology on the inside of the pulley prevents belt slippage. Compatible with any known flat-plate hoist. Resistant to warping. Designed to fit drive belts better. The bore is 3/4 inches. Accepts belts up to 1/2 inch.

The AX-34 is a 34-inch drive belt that is compatible with all flat-plate boat hoists from BH-USA. This belt is the perfect length to fit around a 10-inch hoist pulley and to be able to attach it to a 2-inch motor pulley. As the motor’s driveshaft turns, the pulleys turn the belt in order to complete the movement of the hoist.